Quick Change Discs

Quick Change Discs

Specification

Material：Premium Zirconium Oxide /Ceramic Grain/Silicon Carbide/Aluminium Oxide
Backing：Plastic Backing / Metal Hub
Type：R / S
Grit：#24– #1200
Diameter: 25mm,50mm,75mm

Features

Easy exchange, maintain secure attachment at high speeds
Ideal for use in hard to access and awkward areas
High polishing rate, prevent clogging

Suitable for

Quick Change Zirconium Oxide Sanding Discs are available in a range of sizes, coarse grits and quick change sanding systems.

Particularly used in hard-to-reach areas and perfect for grinding small narrow areas.

LEAVE MESSAGE CHAT ONLINE

 Data download

 Product video

Size		Type	Abrasive
mm	Inch
25	1	TS, TP, TR	Non-woven cloth, ZA, AO, CER, SiC
50	2
75	3



Quick change discs are available in a range of sizes,coarse grits and quick change sanding systems. Particularly used in hard-to-reach areas and perfect for grinding small narrow areas.
Quick Change Discs allow tool-free swap outs, maintain secure attachment at high speeds, and save operators’time


Quick change disc is used for grinding welding seams, flat surface. Metal processing, automobiles, motorcycle sheet, metal coating,etc.

Safety Tips
Don't grind near flammable materials. Grind and sand in well-ventilated areas whenever possible. Wear eye and face protection when working with any abrasive products. Wear a dust mask or approved respiratory protection. Check the packaging for the materials you're abrading or grinding to see which is recommended.
Wear hearing protection. Pay attention to the noise exposure, and make sure you're protected when it exceeds established threshold levels.
Wear safety gloves. Pay attention to where sparks are flying. Direct sparks away from your body and away from anyone else in the room.
Don't wear loose-fitting clothing while grinding. Wear long-sleeved shirts or arm guards and long pants. If the tool you're working with starts to chatter or vibrate, stop at once. Find the cause of the problem, and fix it before you go any further. Use your abrasives on a first-in, first-out basis. Rotate your stock to keep the oldest abrasives ready at hand.