Silicon Carbide Flap Wheel

Silicon Carbide Flap Wheel

Specification

Material: Silicon Carbide Abrasive cloth
Specification: Diam.100-350mm, Thickness 20-100mm
Backing: Polyester/Polycotton/pure cotton
Grit Range: 24-1000#

Features

High quality silicon carbide cloth
High working efficiency stable grinding quality
No burning work-pieces
Easily continuous operating

Suitable for

Nonmetal, non ferrous metal surface grinding and polishing, weld seams grinding, rust removing

LEAVE MESSAGE CHAT ONLINE

 Data download

 Product video

Specification			Abrasive grain	Grit No.
Diam.(mm)	Height(mm)	Thickness(mm)
150	25	25/32	Silicon Carbide	40#-1200#
200	25	25/32	Silicon Carbide	40#-1200#
	30
	40
	50
250	30	25/32/50	Silicon Carbide	40#-1200#
	40
	50
300	25	25/32/50127	Silicon Carbide	40#-1200#
	30
	40
	50
	60
	70
	80
	90
	100
350	60	145	Silicon Carbide	40#-1200#
	70
	80
	90
	100
All specification can be customized.



Slicon carbide flap wheels are conformable to intricate shapes and contours, high quality silicon carbide abrasive cloth, high working efficiency, stable grinding quality, no burning working-pieces, easily continuous operating.


Slicon carbide flap wheels are conformable to intricate shapes and contours. Design to deliver a consistent finish with a uniform rate of cut, flap wheels wear away, continually exposing fresh abrasive.


Good brightness after grinding, can be used as one-time grinding, no need last procedure of polishing.


Flap wheels are an ideal choice for a wide variety of blending, deburring and finishing applications common in the metal fabrication, welding and polishing wood industries.

The first is the protection problem, the protective cover is the main protective device of the polishing machine, its role is, when the flap wheel is damaged in the work, can effectively cover the impeller, to ensure the safety of personnel.
Secondly, the balance of the flap wheel is mainly caused by the manufacture and installation of hundreds of flaps of inaccurate, so that the center of gravity and rotary shaft do not coincide.The harm caused by the imbalance is mainly shown in two aspects, on the one hand, in the high speed rotation of the vane wheel, cause vibration, easy to cause the workpiece surface polyangular vibration marks, on the other hand, the unbalanced acceleration of the spindle vibration and bearing wear, serious will cause the vane wheel page rupture, even cause accidents.
Matching problem.The matching problem mainly refers to the installation problem of chuck and flaps. According to the standard requirements, the diameter of the chuck shall not be less than 1/3 of the diameter of the installed sand disc, and the corresponding provisions wear to the diameter larger than the chuck 10mm should be replaced with a new flap wheel.